Chapter 5 Customizing NV DVR System
-Enable/disable the Abnormal Event check box, to set the condition of the event for system to alarm.
•Normal Reboot: when the NV DVR system reboot without abnormal condition, the system will send out the alarm message.
•Abnormal Reboot: when the NV DVR system reboot in irregular condition, the system will send out the alarm message.
•Recording is switched off: when the recording has been stopped, the system will send out the alarm message.
•Network is switched off: when the network connection of DVR system is lost, the system will send out the alarm message.
•Hard Disk failed: when the hard disk can’t work normally, the system will send out the alarm message.
•Temperature: set a temperature limited of system for system to alarm. When DVR system temperature is over the temperature limited, the system will send out the alarm.
iTemperature setting only supports on NV6000 Express card.
•Illegal Entry: any objects move between selected regions which user has set up in Object Counting section (see Chapter 5.2.1), the system will send out the alarm. Select the entry (object moves from region 1 to 2 or from region 2 to 1) and camera for system alarm detection.
iOnly the camera has been setup in Object Counting will be available for selecting in Illegal Entry.
-Enable/disable the POS Keyword check box, to scan the data from the POS if it matches the keyword (see also Chapter 5.9.10).
-Enable/disable the Alarm Message check box, to active with external alarm message by your own program. For the detail configuration, please contact the local reseller.
-Continue trigger duration: Set a time period that when sensor has been trigger and stay in the same status for that period, then the alarm will be sent out.
6.In (5) Alarm Reset, click the camera number (use W and X to select the alarm) to set the reset condition of alarm. Once alarm is reset, all alarm action will stop at the moment. If the sensor normal status is high, set the sensor condition to low.
62