7

 

CHAPTER

Basic Operations

 

 

 

 

 

3

 

 

Powering the AutoView Wireless Switch

To power the AutoView Wireless switch:

1.Complete all of the installation steps in Chapter 2.

2.Power up the AutoView Wireless transmitters and wait for the LED mark S2 to illuminate.

3.Power up the monitors attached to the AutoView Wireless receivers.

4.Power up the AutoView Wireless receivers.

5.Power up the attached computers.

NOTE: Always power up the AutoView Wireless transmitter and wait for the middle LED marked S2 to illuminate before powering up any attached computers.

LEDs

Both the AutoView Wireless transmitter and receiver contain three LEDs visible from the front of each unit. The LEDs are labeled on the unit.

Figure 3.1: Transmitter LEDs

Table 3.1: LED Conditions

S1

S2

PWR

Condition

 

 

 

 

OFF

OFF

ON

No Switch Activity, Power is On

 

 

 

 

OFF

OFF

OFF

No Switch Activity, Power is Off

 

 

 

 

OFF

ON

ON

Ready to Establish Link

 

 

 

 

ON

ON

ON

Connected