12Digital Desktop System Installer/User Guide

Configuring the Desktop Appliance

Perform the following steps if you wish to change the FLASH write settings or disable on-board video for the Desktop Appliance. The factory default is set to allow both local and remote write access to the FLASH settings. If you do not wish to change these settings then you may skip to the next section, Installing Drivers. Figure 2.7 shows the FLASH jumpers. Table 2.2 indicates the FLASH type for each jumper.

 

J11

J12

J13

Enable

 

 

1

 

 

 

2

Disable

 

3

Figure 2.7: Video and FLASH Jumpers

 

Table 2.2: Jumper FLASH Types

 

 

 

 

 

Jumper

FLASH Type

 

 

 

J11

On-board video enable

 

 

J12

Remote FLASH write

 

 

 

J13

Local FLASH write

 

 

 

 

 

NOTE: The DWorks Administration Utility is required to access the FLASH contents. Local FLASH write enable refers to execution of the DWorks Administration Utility from the Digital Desktop System being configured. Remote FLASH write enable refers to configuration of a PCI Add In Card or Desktop Appliance using the device’s Ethernet address over a switched network.

To configure the Desktop Appliance:

1.Ensure that the Desktop Appliance is powered down.

2.Locate and remove the four screws (two on each side of the unit) that allow you to remove the top housing.

3.Configure the jumpers for the desired setting.

4.Install and secure the top housing.

To install a third party PCI Add In Card:

1.Ensure that the Desktop Appliance is unplugged and powered off.

2.Locate and remove the four screws (two on each side of the unit) that allow you to remove the top cover.

3.Remove the top cover.