Axis Communications 207W user manual Browser, Wireless network from a browser

42AXIS 207W/AXIS 207MW - Troubleshooting

Symptoms, Possible Causes and Remedial Actions

Problems setting the IP address
When using ARP/Ping	Try the installation again. The IP address must be set within two minutes after power has
	been applied to the camera. Ensure the Ping length is set to 408. See the Installation
	Guide.
The camera is located on a different	If the IP address intended for the camera and the IP address of your computer are located
subnet	on different subnets, you will not be able to set the IP address. Contact your network
	administrator to obtain an appropriate IP address.
The IP address is being used by	Disconnect the camera from the network. Run the Ping command. (In a Command/DOS
another device	window, type ping and the IP address of the unit).
	If you receive: Reply from <IP address>: bytes = 32; time = 10 ms..... - this means that
	the IP address may already be in use by another device on your network. You must obtain a
	new IP address and reinstall the unit.
	If you see: Request timed out - this means that the IP address is available for use with
	your camera. In this case, check all cabling and reinstall the unit.
Possible IP address conflict with	The static IP address in the camera is used before the DHCP server sets a a dynamic
another device on the same subnet	address. This means that if the same default static IP address is also used by another
	device, there may be problems accessing the camera. To avoid this, set the static IP address
	to 0.0.0.0.
The camera cannot be accessed from a	browser
The IP address has been changed by	1) Move the camera to an isolated network or to one with no DHCP or BOOTP server. Set
DHCP	the IP address again, using the AXIS IP Utility (see the Installation Guide) or the ARP/Ping
	commands.
	2) Access the unit and disable DHCP in the TCP/IP settings. Return the unit to the main
	network. The unit now has a fixed IP address that will not change.
	3) As an alternative to 2), if dynamic IP address via DHCP or BOOTP is required, select the
	required service and then configure IP address change notification from the network set-
	tings. Return the unit to the main network. The unit will now have a dynamic IP address,
	but will notify you if the address changes.
Other networking problems	Test the network cable by connecting it to another network device, then Ping that device
	from your workstation. See the instructions above.
The camera cannot be accessed on the	wireless network from a browser
The wireless settings in the camera do	Connect the network cable and check that the SSID and security settings are identical in
not match those in the wireless access	the camera and in the access point.
point.
Unsupported/disabled protocols.	The AXIS 207MW supports the 802.11b and 802.11g wireless standards. Check that the
	wireless access point supports at least one of these and is enabled.
Wireless access point requires MAC	Check if the camera’s MAC address (this is the same as the product’s serial number) needs
address registration.	to be registered in the wireless access point before being allowed to access the wireless
	network. Check the access point’s settings and/or documentation.
Camera is accessible locally, but not externally
Broadband router configuration	To configure your broadband router to allow incoming data traffic to the camera: Enable
	the NAT-traversal feature which will attempt to automatically configure the router to
	allow access to the camera.
	This is enabled from Setup > System Options > Network > TCP/IP Advanced.
Firewall protection	Check the Internet firewall with your system administrator.
Default routers required	Check if you need to configure the default router settings.