Installing Axis 233 Camera
1.Note the position of the mounting holes on the camera bracket (see diagram below).
Camera Bracket Mounting holes
Mounting holes for housing
2.Since the 233 camera operates on 24vac, the power board that is located inside the housing is not needed. The remove the power board, start by loosening the screws on the terminal block and disconnect the orange and red wires.
3.With a Phillips head screwdriver remove the (4) machine screws holding the power board to the base bracket. Remove the power board.
Machine screws (4)
Base Bracket
4. Now remove the Base Bracket.
5.Now attach (4) 1” spacers (located in the packet that came with the housing) to the base bracket.
Attach (4) 1" spacers
1"
- 10 -
