Page 6 | AXIS 210/210A/211/211A Installation Guide |
Install the hardware
! IMPORTANT! - The 210/210A is designed for indoor use only, and must always be positioned where it is not exposed to direct sunlight or strong halogen light, which can cause permanent damage to the camera’s image sensor. Damage as a result of exposure to strong light is not covered by the Axis warranty.
IMPORTANT! - The AXIS 211/211A is designed for indoor and outdoor use. To use the camera outdoors, it must be installed in an approved outdoor housing. Please see www.axis.com for more information on outdoor housings.
Connect the camera
1.Connect the Network Camera to your network using a standard network cable. Using Shielded Twisted Pair (STP) cables is recommended.
2.Optionally connect external input/output devices, e.g. alarm devices. See page 15 for information on the terminal connector pins.
3.Optionally connect an active speaker and/or external microphone.
4.Connect power, using one of the methods listed below:
•The supplied power connector.
•Power over Ethernet (PoE). If available, this is automatically detected when the network cable is connected (see above).
•The I/O terminal connector on the rear panel.
5.Check that the indicator LED:s indicate the correct conditions. See the table on page 16 for further details. Note that some LED:s can be disabled and may be unlit.
