Axis Communications AXIS 216FD-V Adjust the image and focus, Complete the installation, Position

AXIS 216FD/216FD-V/216MFD/216MFD-V Installation Guide Page 11

Adjust the image and focus

Open the Live View page in the web interface and make the following adjustments to the camera:

1.	Loosen the locking screw and	Image
	tilt adjustment screws.
		balance
2.	Turn the lens to the desired		Focus puller
		ring		Zoom puller
	position.

3.Once satisfied, gently tighten the locking screw and tilt adjustment screws to secure the camera’s position.

4.Turn the image balance ring to set the horizontal position.

5.Open the Focus Adjustment page in the Web interface under Basic Configuration > Focus and follow the on- screen instructions. Use the image window to adjust the focus and zoom.

Tilt adjustment screw

	Tilt adjustment
Locking screw	screw

ENGLISH

6.To set the focus and zoom,

loosen the zoom and focus pullers anti-clockwise and rotate the rings.

Note:

Due to the dome’s refraction, the image might appear slightly out of focus once the dome has been placed. To compensate, focus on an object slightly closer than the inteded area.

7. Lock the focus and zoom pullers in position by rotating the screws clockwise.

The image can also be fine-tuned for low lighting conditions.

Go to Setup > Video & Image > Advanced and see the online help for more information.

Complete the installation

1.Rotate the black protective shield inside the dome casing to match the camera’s position.

2.Clean the dome with a dry soft cloth to remove dust and finger prints and use a blower to remove dust from the lens.

3.Mount the dome casing using the supplied tamper-proof screws and screw driver.

4.Now that the dome is in place, double-check that the camera is properly focused.

5.The installation is now complete.