AXIS M11 Series | Page 13 |
Resetting to the Factory Default Settings
To reset all parameters and the IP address to Factory Default settings:
1.Disconnect power from the camera.
2.Press and hold the Control button and reconnect power.
3.Keep the Control button pressed for about 15 seconds until the Status indicator flashes amber. Release the Control button.
4.When the Status indicator displays green (which can take up to 1 minute) the process is complete and the camera has been reset.
5.
Accessing the camera from the Internet
Once installed, your AXIS M11 Series network camera is accessible on your local network (LAN). To access the camera from the Internet, configure network routers to allow incoming traffic, which is usually done on a specific port:
•HTTP port (default port 80) for viewing and configuration
•RTSP port (default port 554) for viewing H.264 video streams Please refer to the documentation for your router for further instructions. For more information on this and other topics, visit the Axis Support Web at www.axis.com/techsup
Further information
The user’s manual is available from the Axis web site at www.axis.com or from the Axis Network Video Product CD supplied with this product.
Visit www.axis.com/techsup to check if there is updated firmware available for the AXIS M11 Series. To see the currently installed firmware version, see Setup > About in the camera’s web pages.
ENGLISH
