AXIS P1344-E Network Camera
Troubleshooting
arp
In Windows, type the following from a command/DOS prompt:
arp -s <IP address> <serial number> ping -l 408 -t <IP address>
2.If the product does not reply within a few seconds, restart it and wait for a reply. Press CTRL+C to stop Ping.
3.Open a browser and type in the product’s IP address. In the page that appears, use the Browse button to select the upgrade file to use. Then click Load to restart the upgrade process.
4.After the upgrade is complete
5.Reinstall the product, referring to the Installation Guide.
If the emergency recovery procedure does not get the product up and running again, contact Axis support at www.axis.com/techsup/
Symptoms, possible causes and remedial actions
Problems setting the IP address
When using ARP/Ping | Try the installation again. The IP address must be set within two minutes after power has been |
| applied to the product. Ensure the Ping length is set to 408. See the Installation Guide for |
| detailed instructions. |
The product is located on a different subnet
The IP address is being used by another device
Possible IP address conflict with another device on the same subnet.
If the IP address intended for the product and the IP address of the computer used to access the product are located on different subnets, you will not be able to set the IP address. Contact your network administrator to obtain an IP address.
Disconnect the Axis product from the network. Run the Ping command (in a Command/DOS window, type ping and the IP address of the product:
•If you receive: Reply from <IP address>: bytes=32; time=10...
this means that the IP address may already be in use by another device on the network. Obtain a new IP address from the network administrator and reinstall the product.
•If you receive: Request timed out, this means that the IP address is available for use with the Axis product. Check all cabling and reinstall the product.
The static IP address in the Axis product is used before the DHCP server sets a dynamic address. This means that if the same default static IP address is also used by another device, there may be problems accessing the product.
The product cannot be accessed from a browser
Cannot log in | When HTTPS is enabled, ensure that the correct protocol (HTTP or HTTPS) is used when attempting |
| to log in. You may need to manually type http or https in the browser’s address field. |
The IP address has been | If the product and the client are on the same network, run AXIS IP Utility to locate the product. |
changed by DHCP | Identify the product using its model or serial number. |
| Move the Axis product to an isolated network, or to one with no DHCP or BOOTP server. Set the IP |
| address again, using AXIS IP Utility or ARP/Ping (see the Installation Guide). Open the Setup pages |
| and disabled DHCP in the TCP/IP settings. Return the product to the main network. The product |
| now has a fixed IP address that will not change. |
Certificate error when using | For authentication to work properly, the date and time settings in the Axis product should be |
IEEE 802.1X | synchronized with an NTP server. See Date & Time, on page 41. |
52
