Raindance Showerhead 28473XX1

Raindance Showerhead 28473XX1

Technical Data

Flow rate at 45 psi 2.5 gpm

Installation:

Make sure that the self-sealing filter gasket is installed in the inlet of the showerhead.

The filter must be installed to protect against damage from debris.

Debris damage is not covered by the Hansgrohe warranty.

If using in an existing shower, remove the old showerhead:

·While holding the shower arm, remove the existing showerhead by turning counter-clockwise with an adjustable

wrench.

· Thoroughly clean the threads on the shower arm with a wire brush.

·Slide decorative rubber boot onto the shower arm, narrow end first. Push it up and out of the way.

·Make sure that the self-sealing filter gasket is fully seated in

the showerhead by grasping the black tab and turning clockwise as far as it will go without forcing it.

·

Screw the showerhead onto the arm, taking care not to

17 mm

 

cross thread.

 

 

· Finish tightening with wrench, taking care not to over- tighten or showerhead and / shower arm may be damaged. Turn on the water and check for leaks. Pull boot down over showerhead ball joint.

User Instructions

Change the spray mode by turning the function ring until the index mark is next to the name of the spray function.

function lever

Rain

Mix 1

Balance

Mix 2

Whirl

Page 2
Image 2
Axor 27483XX1 installation instructions Technical Data, Installation, User Instructions, Raindance Showerhead