To

Turntable

In the event that a four conductor cable is not available, a pair of cables with at least two conductors each may be used as shown in the following diagram, with the DIN connector shown from the rear (solder) side:

Female DIN

Shield

Male XLR

1

To Phono

Preamplifier

1

Ground Wire

Spade Lug

In this situation extra care must be taken to provide a flexible section to avoid interference with the turntable’s suspension. If the cabling has three conductors (in addition to the shield), the third conductor should be connected to pin 1 of the XLR connectors and left unconnected at the tonearm end.

14

Page 16
Image 16
Ayre Acoustics P-5XE owner manual Female DIN Shield