Azden WLTPRO Whx-Pro, x WR-PROVHF Receiver, x WM/T-PROVHF Transmitter/Handheld Microphone

Thank you for purchasing the AZDEN PRO VHF Wireless Microphone System. The following will show you the contents of the system you ordered:

WHX-PRO

1 x WR-PRO VHF Receiver

1 x WM/T-PRO VHF Transmitter/Handheld Microphone

WLX-PRO

1 x WR-PRO VHF Receiver

1x WM-PRO VHF Belt-Pack Transmitter

1x EX-503 Lavalier Microphone

WMS-PRO

1 x WR-PRO VHF Receiver

1x WM-PRO VHF Belt-Pack Transmitter

1x EX-413 Wired Handheld Microphone

The PRO systems operate in the low-interference VHF band and have 2 switchable frequen- cies, 169.445 (F1) and 170.245 (F2). You should select the quieter frequency for use.

The systems conforms to Part 90 of the FCC rules. You should contact the FCC office for fil- ing forms.

WR-PRO RECEIVER

1. Loading Battery

Open the battery compartment lid by sliding it down and raising the lid. Insert a 9- volt battery into the battery compartment with the correct polarity. Directions are on the inside of the battery compartment. Do not force the battery compartment l id to close. If it does not close easily, turn The battery around and try again.

2. Power/Frequency Selector Switch

This slide switch is used to turn the unit on and off as well as to select a frequency. When not using the WR-PRO, make sure that the switch is turned to OFF.

2