3. Signal Indicator
This LED has 2 functions: When you first turn the Power/Frequency Selector Switch of the Receiver on, but if the Transmitter is not on, the LED will go on and off indi- cating that the battery is good. If both the Transmitter and the Receiver are on and they are on the same frequency, the Signal Indicator will remain on.
4. Shoe Mount
The Receiver comes with a shoe mount and
5. Output Plug
Connect the plug from the Receiver into the camera’s “EXT. MIC’ jack.
6. Telescopic Antenna
Fully extend the antenna for the best reception.
7. Earphone Jack
Plug the supplied earphone into the jack to monitor the sound you are recording.
WM/T-PRO TRANSMITTER/MICROPHONE
1. Loading battery
Turn the bottom half of the microphone body counterclockwise until it is completely off. Insert 1 “AA” battery into the compartment. Make sure the polarity is correct or the unit will not operate. Replace the bottom half and turn it clockwise until it is snug. DO NOT OVERTIGHTEN.
2. Frequency Selection
The unit is factory
3.
The bottom position is “OFF”, the top is “ON”, and the middle is ”STANDBY”. In the “STANDBY” position, the unit is on but the microphone is muted. This allows the microphone to be passed around noiselessly. Remember to set the mic to its “ON” position before speaking. When the switch in “ON” or “STANDBY”, the red LED will stay lit if the Receiver is also operating on the same frequency.
3