CHAPTER 3: SERIAL TO PARALLEL
INSTALLATION
When converting data from your serial port to a parallel communication format, position #8 of the dipswitch must be "OFF". The other seven positions should be set to match the data format of your computer's serial port. Refer to Table 5.1 for dipswitch setting specifications.
CONNECTING THE 232SPS2 TO YOUR PARALLEL PRINTER
The 232SPS2 has a
CONNECTING THE 232SPS2 TO YOUR SERIAL PORT
The connections required between your 232SPS2 and your serial port depend on the type of flow control used. The type of flow control used depends on the software you are using. If you are unsure which type of flow control your software uses or if you plan to run different kinds of software, you should use a cable that connects all 9 pins from connector to connector and set the handshaking mode to be XON/XOFF control. In this mode both DTR handshaking and XON/XOFF control are used for flow control. Dipswitch position #4 should be "OFF" for XON/XOFF control. For more detailed information on serial port connections, refer to Appendix B.
4232SPS24595 Manual
B&B Electronics
PH (815)