EIR102
© 2008 by B&B Electronics. All rights reserved.
Attach RJ45 Cable |
| Fiber Optic Cable |
(If equipped) |
| Information |
Female Connector
1.Auto
2.10/100BaseT auto negotiation and full/half- duplex are supported. Speed and duplex can also be forced. Refer to DIP Switch settings.
MDI Cable Pinout
Pin Signal
1Tx+
2Tx-
3Rx+
6Rx-
MDI-X Cable Pinout
Pin Signal
1Rx+
2Rx-
3Tx+
6Tx-
Fiber Optic Cable Information
Mode and Distance | Type | Wavelength |
62.5/125 µm | 1310 nm | |
9/125 µm | 1310 nm | |
9/125 µm | 1310 nm | |
9/125 µm | 1550 nm |
| Output Power | RCVR Sensitivity |
≤ | ||
≤ | ||
≤ | ||
≤ |
Installation Complete
1.When the network cables are attached and power is applied, installation is complete.
QUICK START GUIDE
Attach Fiber Optic Cable
Warning: Work Safe – This is a Class I Laser/LED device. To avoid causing serious damage to your eyes, DO NOT STARE DIRECTLY INTO THE LIGHT.
NOTE: Recycle power if DIP Switch changes are made after power up.
Mechanical Diagram
B&B ELECTRONICS
1.Ensure your fiber optic cable is terminated with the correct connector type. EIR102 Media Converters use SC or ST connectors.
2.Fiber optic type for each port is located on the product’s side label. When connecting the cable to the media converter, be sure to line up the slider guide on the cable and media converter connectors.
3.Connect the fiber optic transmitter to the downstream device’s receiver and
International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland