Baby Trend 11.07 manual To Secure Child, To Secure FRONT/REAR Sitting Children

6. To attach the front child tray, push the tray onto the front frame tube, lining up the tray between the protruding rivets. Push backward on the latch until snapped into place. The protruding rivets on the outside of the frame tube should be between the tray latch. Check that the tray is securely latched in place. Fig. 5 and Fig. 6.

7. To remove front child tray, pull outward on the latches and pull outward on the tray. Fig. 7. Please note that you may attach or remove one end at a time.

WARNING: The child’s tray is not a restraint device: always secure your child with the seat belt. DO NOT lift the stroller by the child’s tray. Use care when attaching the child’s tray on the stroller with a child in the stroller.

8.To attach the front canopy, line up the male fittings on the canopy with the female fittings on the armrest and push both fittings downward until snapped into place. Fig. 8. Push forward on the front edge of the canopy to open.

9.To attach the rear canopy line up the female fittings of the canopy with the male fittings on the handle frame tube and push downward. Fig. 9.

10.To remove rear canopy reverse installation steps and pull up to remove. Fig. 9A.

11.To remove front canopy depress the plastic attachment and pull upward to remove. Fig. 9B.

WARNING: Avoid serious injury from falling or sliding out. Always use the seat belt.

TO SECURE CHILD

TO SECURE FRONT/REAR SITTING CHILDREN

1 The shoulder straps of the 5-point harness has 2 attachment positions. Select the loop position that places the shoulder strap level with, or below the top of the child’s shoulder and feed the shoulder harness under the correct loop. Fig. 10.

2. Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap and between the child’s legs. Insert the male end of each shoulder / waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders. Fig.11.

3. To release, apply pressure to both sides of each male clip until the clip is released. This process requires a moderate amount of effort so as to prevent an accidental release by your child. NOTE: Buckles may be hard to release when 1st used.

Fig. 5.

Rivet

Fig. 6.

Fig. 7.

Fig. 8.

Fig. 9.

Fig. 9A.

Fig. 9B.

4

Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.