Baby Trend 11.07 manual To Secure Rear Standing Child, To USE Jump Seat

TO SECURE REAR STANDING CHILD

1. The rear platform and jump seat are designed to accommodate a child who is at least 2 1/2 years old, has good balance and coordination, and is not over 40 inches tall. Position the child on the platform on the back of the stroller. Be sure child is facing forward and hands are holding frame. Secure the safety belt behind child and engage buckle. Fig. 12.

2. Be sure that the child’s feet are fully on the platform at all times. PLEASE NOTE: When using the rear SEAT you must put the STAND FEATURE SAFETY BELT in the storage location located on the rear of the seat. Please See Fig. 12A

WARNING: To avoid a possible choking hazzard when using the rear seat, put the STAND FEATURE SAFETY BELT in the storage location on the rear of the seat.

Fig. 10.

Shoulder Strap

Waist	Squeeze	Fig. 11.
Strap
		Adjust for a
Crotch Strap		snug fit

Fig. 12. Fig. 12A. Fig. 12B.

TO USE JUMP SEAT

STEP ONE: REMOVING THE REAR SEAT

1.Remove the rear canopy by sliding the square fittings upward until they disconnect from the frame.

2.Remove the rear seat from the frame by un-buttoning the upper and lower seat back fabric from the frame (Fig. 13 & 14) and un-snaping both front connection points. Fig. 15

3.Detach the (2) shoulder straps from the frame by folding and sliding the strap through the “D-ring” located on the end of each strap. Fig. 16.

4.Detach the center crotch strap from the frame by folding and sliding the strap through the “D-ring” located on the end of the strap. Fig. 17.

Upper

Fig. 13

Snap point

Lower

Fig. 14 5

Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.