PARTS
|
|
|
| Locking Washer (2) |
| Child Tray | Rear Wheel (2) |
| |
|
|
|
| |
|
| Parent Tray |
| Hub Cap (2) |
Car Seat | Stroller | Rear Axle Assembly | Front Wheel (2) | Solid Cap (2) |
TO ASSEMBLE STROLLER
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1. | Carefully remove stroller from the carton. Note: Front wheels, rear |
|
|
| wheels, child tray and parent tray MUST be installed before using. |
|
|
2. | Unfold stroller frame by sliding the RED thumb trigger to the left and |
|
|
| squeezing the RED pull trigger while pulling backward on the stroller |
|
|
| handle. (Fig. |
|
|
3. | To attach the front wheels, lean the stroller back so that it rests on the |
|
|
| handle with the front and rear legs pointing upward. Position the front |
|
|
| wheels over the front leg tubes so that the hole in the housing lines | Fig. 1 | Fig. 2 |
| up and will slide onto the legs. (Fig. 3) Firmly push down until the |
|
|
| wheels lock securely into place. Tug on each wheel to ensure they are |
|
|
| both securely attached. |
|
|
4. | Attach the rear axle assembly and wheels as follows: |
|
|
| a. Position axle assembly over the rear leg tubes, brake pedals |
|
|
| facing the back. At the same time, push down applying equal |
|
|
| pressure to both sides until they lock into place. (Fig. 4) |
|
|
| b. Slide a wheel onto each side of the axle. (Fig. 5) |
| Fig. 3 |
c.Secure both wheels using with a locking washer. Push locking washer firmly in place. (Fig. 6a)
d.Cap axle end using the solid metal caps. (Fig. 6b)
e.Cover and finish using hubcaps. (Fig. 6c)
Pull on both wheels to ensure they are secure and can spin freely. | Fig. 4 | ||
Note: DO NOT use stroller if wheels do not lock into place. If you |
| ||
need assistance, please contact our customer service department at |
| ||
(800) |
|
|
|
c | b | a |
|
Fig. 5 | 3 |
