PARTS
Rear Axle
Child Tray
Base | Locking Cap |
|
Rear Wheels
Parent Tray
Hub Cap
Car Seat | Stroller | Rear Wheel Housing | Front Wheels | Solid Cap |
|
|
|
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
TO ASSEMBLE STROLLER
*Remove stroller from box. The front wheels, rear wheels, child tray, parent tray, and canopy need to be installed prior to use.
*To attach the front wheels, unfold stroller as described in the section following. See figure 1.
*Lean the stroller backwards so that it rests on the handle and rear frame tubes and the front wheel tubes are pointing upward. Position the front wheel assembly at the front tube such that the hole in the swivel assembly will slide onto the front tube. Please see figure 2. Push each front wheel assembly onto the front tube being careful that wheel assembly locks onto the front leg. Pull on the wheel assembly to ensure that it is securely attached to the stroller. Please see figure 2.
*Lean the stroller forward to rest on the front wheels. Assemble the rear wheels as follows:
1.Slide the rear wheel housings onto each rear stroller leg until locked into place. The push button on the forward edge of the leg should snap into the hole in the housing. Please see figure 3.
2.Slide the rear axle through the housings as shown in figure 4.
3.Slide each wheel onto the rear axle and secure in place with the Locking Cap. Snap the solid cap over the Locking Cap. Snap the
Hub Cap onto the wheel. Please see figure 5. Please see figure 6 for order assembly.
Pull on each wheel to ensure that each is firmly attached to the axle.
*Ensure that the wheels are firmly locked into place. Do Not use the stroller if the wheels are not locked into place, but rather contact our customer service department immediately at (800)
Figure 6. | Figure 5. |
Figure 1.
Figure 2.
Figure 3.
Slide axle through |
|
Figure 4. | 3 |
|
