33
Intercom, line status, auto-answer, privacy or auto-line selection are inoperable.
vCheck if Lines 1 and 2 are cross wired in the wall jack.
vIf used, see if you may have installed your 2-line adapter incorrectly.
vBe sure all extensions in the system are connected to [LINE 1].
vCheck the assigned extension codes, making sure they are unique.
vBe sure the length of cable between stations does not exceed 300 feet.
vCheck that all phone lines are correctly connected to each station (every [LINE 1] is connected to
the appropriate line, every [LINE 2] is connected to the appropriate line, and so on.)
vRemove all RFI filters from the system wiring. You may also need to contact your local telephone
company to have any RFI filter removed from the company side of the connection.
No dial tone/phone will not dial out.
vCheck that you have plugged the AC power adapter into a working AC power outlet.
vConfirm that the AC power adapter is plugged into the DC jack locates at the unit.
vCheck all telephone cord connections.
vTry another wall jack.
vMake sure the line connection is programmed ON.
Can’t hear the ring signal.
vCheck the ringer volume controls. At lowest level the ring may not be heard.
vCheck the status of DND (Do Not Disturb). Make sure the DND LED is not lit.
Can’t hear the ring signal on one line only.
vCheck the ringer setting on that line.
vSee Programming Ringer ON/OFF.
While on a call do you hear another call on the line or are you experiencing radio frequency
interference?
vMake sure all wiring is twisted pair, including modular cords on non-system devices.
vCheck the wiring for bad connections.
Reaching the wrong number in speed dialing.
vCheck that you are accessing the correct dial group (see speed dialing).
TROUBLESHOOTING