Baby Trend 8207BCC manual To Assemble Playard, Contents Fig

TO ASSEMBLE PLAYARD

FOR THE SAFETY OF YOUR CHILD, PLEASE READ THE INSTRUCTIONS COMPLETELY

BEFORE ASSEMBLING THE PLAYARD, BASSINET AND CHANGING AREA

CONTENTS (Fig. 1-1):

1 Playard

1Mattress

1 Organizer

2 Leg extensions (1 Left,1 Right)

2 Leg extensions (1 Left, 1 Right) with Wheels, and hardware

1 Travel or Storage bag

BEFORE YOU BEGIN: The Baby Trend Playard is designed so that, when properly setup, the fabric of the playard places pressure on the 4 top rails making them nearly impossible to unlock. This safety feature is activated when you push down on the playard floor to lock the bottom rails. When setting up the playard, if you allow the bottom rails to lock before locking the top rails, the fabric pressure will not allow you to lock the top rails. Please see (Fig. 7.) for the proper position of the bottom of the playard when locking the top rails. Always keep fingers away from corners when setting playard up.

1.Unzip bag and remove Playard frame (Fig. 1). Undo the 3 Velcro straps and set mattress aside (Fig. 2).

2.Turn the playard upside down. (Fig. 3). Push each leg extension into the bottom of the leg until both sides of extension snap into place. (Fig. 4). Check that the extension is firmly connected. Attach the wheels to the playard with the axle and nut as shown in figure (Fig. 5). The brake cluster on the wheel must face to the inside. The axle is inserted from the outside to the inside. (Fig. 6). Check that the wheels are firmly connected.

3.Stand Playard on legs keeping feet of playard close together as shown in (Fig. 7). Pull up on top rails until all rails “click” and “lock”.

*READ IMPORTANT: In order to continue, the handle in the center of the floor of the Playard MUST remain raised in order for the rail to lock (approx. 45.7 cm or 18 inches). The feet of the playard should almost touch each other. All 4 bottom rails must be pointed upward in order to LOCK top rails.

Figure 1-1.

Figure 1.

Figure 2.

Leg extensions

4.Push down on center of Playard floor until it is flat and locks into position (Fig. 8). The center lock mechanism will lock automatically. The center lock will rotate clockwise about 90 degrees as it locks.

NOTE: Test rails to make sure they are locked. Push down on each rail making sure they are rigid and in a set position.

Wheels

Figure 3

3

Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.