Bacharach Tech 60 quick start Sampling Locations, Water Trap / Filter Maintenance, Fyrite Tech 50

Sampling Locations

Insert the probe in the areas shown in the following illustrations to measure stack temperature, flue-gas O2 content, and flue-gas CO content (Model 60 only).

Atmospheric Burner or

Gravity Vented Forced Air

Hot Water

Tank

80% Eff. Fan Assist or Power Vented Furnace/Boiler

90% Eff.

Condensing

Furnace/Boiler

Water Trap / Filter Maintenance

Drain the water condensate collected in the water trap after every test.

Replace the filter element (P/N 07-1644) when dirty.

Pull apart using a slight twisting motion

Fyrite® Tech 50 & 60

Quick Start Guide 24-9429

Rev. 1 – September 2003

This Guide provides basic information about how to turn ON the analyzer and conduct a combustion efficiency test. Detailed information concerning the analyzer’s operation, set up, and calibration is contained in Instruction 24‑9428.

Turning ON the Analyzer

1.Place the probe tip in the area that contains the burner’s combustion-air source. This step allows the analyzer to measure the combustion-air temperature during the analyzer’s warm-up period.

2.Press analyzer’s I/O button.

3.Wait for the analyzer to complete its 60 second warm-up period.

Performing a Combustion Test

4.Press the  or  button to select the desired fuel and then press ENTER. The fuel codes are:

F1 = Natural Gas	F3 = LPG
F2 = Oil #2	F4 = Kerosene

Atmospheric or Gravity Vented Boiler

WATER TRAP	FILTER
CHAMBER	CHAMBER

Pry apart filter chamber using a small flat-blade screwdriver inserted into notch

FILTER ELEMENT

“A” When reassembling “B” the trap, make sure

that surfaces “A” and “B” are in contact

Example: “F1” denotes

Natural Gas

Bacharach, Inc.

621 Hunt Valley Circle, New Kensington, PA 15068

Ph: 724-334-5000 • Fax: 724-334-5001 • Toll Free: 800-736-4666 Website: www.bacharach-inc.com • E-mail: help@bacharach-inc.com

- 5 - - 6 - Printed in U.S.A. ® Registered Trademark