2-4 Cam Assembly Adjustment
Figure 7.
The cam assembly P#(A0422), which controls the blower belt tension, comes from the factory
Figure 6.
Cam Assy.
Lower Mount Tube
Bad Boy Receiver Hitch
Fasten Here w/
(1)5/8” x 3” Clevis Pin
(1)Hair Pin Clip
|
|
| |
|
| Place the lower mount tube stiffener P#(B0247) between | |
|
| the lower mount tube (previously installed) and the | |
|
| mower’s rear frame positioning the bend flaps | |
|
| downwards (Figure 8). Fasten to the mower’s rear frame | |
|
| by using (2) | |
|
| washers P#(K0041) and (2) | |
Cam Stop |
| P#(K1246). Fasten to the lower mount tube by using (1) | |
Tension Rod | |||
Bolt | |||
| P#(K1215). Tighten all nuts and bolts. | ||
|
|
2-5 Lower Frame Installation
Figure 8.
Fasten w/
(1) 3/8”
(2) 3/8” Flange Nuts
NOTE: Before continuing installation, you must install the Bad Boy Pup Series
Slide the short leg of the lower mount tube P#(B0246) into the Bad Boy
Lower Mount TubeLower Mount Tube Stiffener
Fasten w/ (2) ½” x1” HHCS
(2)Fender Washers
(2)½” Flange Nuts
7