
Step 9
Before Lighting
the Appliance
Step 10
Lighting the
Appliance
After the
Installation
Before lighting the appliance, be sure to do the following:
Review safety warnings and cautions
•Read the Safety and Warning Information section at the beginning of this Installers Guide.
Double-check for gas leaks
•Before lighting the appliance,
•Before lighting the appliance,
Double-check for faulty components
•Any component that is found to be faulty MUST BE replaced with an approved component. Tampering with the appliance components is DANGEROUS and voids all warranties.
A small amount of air will be in the gas supply lines. When first lighting the appliance, it will take a few minutes for the lines to purge themselves of this air. Once the purging is complete, the appliance will light and will operate normally.
Subsequent lightings of the appliance will not require this purging of air from the gas supply lines, unless the gas valve has been turned to the OFF position, in which case the air would have to be purged.
You’ve reviewed all safety warnings, you’ve checked the appliance for gas leaks, you know the vent system is unobstructed, and you’ve checked for faulty components. Now you’re ready to light the appliance.
WARNING
PLEASE REFER TO THE USER’S MANUAL FOR ALL CAUTIONS, SAFETY, AND WARNING INFORMATION PERTAINING TO THE LIGHTING AND OPERATION OF THE APPLIANCE.
LEAVE THIS INSTALLATION MANUAL WITH THE APPLIANCE FOR FUTURE REFERENCE.
18