Manuals / Heat & Glo LifeStyle / Household Appliance / Indoor Fireplace

Heat & Glo LifeStyle AT-GRAND manual Standing Pilot Continued, Part Description, Part Number

Models: AT-GRAND

1 26

Page 25

Standing Pilot Continued
PART	PART DESCRIPTION	PART NUMBER
	Burner	SRV475-328A
	Burner Orifice NG	SRV57-800
	Burner Orifice LP	SRV60-801
	Rotory Switch	SRV436-525A
	Glass Door Assembly	GLA-ATG
	Grate Assembly	SRV475-360A
	Refractory	SRV459-337

Page 25

Image 25

Heat & Glo LifeStyle AT-GRAND Standing Pilot Continued, Part Description, Part Number, SRV475-328A, SRV57-800, Gla-Atg

Contents

Heat-N-GloFireplace Installers GuideAT-GRAND ModelOwners Guide SAFETY AND WARNING INFORMATIONTHIS UNIT IS NOT FOR USE WITH SOLID FUEL MAY BE USEDTable of Contents and Codes Approvals and CodesMODEL LABORATORYIntroducing the Heat-N-Glo Gas Appliances Pre-installationPreparationGetting Started ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE HAZARDVENTING AND INSTALLATION SURROUND ON/OFF SWITCH LOW VOLTAGE Figure 1. Diagram of the AT-GRANDThe vent system configuration to be used DEPTHStep Installing the Vent System Installing the InsertVent System Installation Precautions Vent System ApprovalsPROBLEMS, IT IS RECOMMENDED TO SEAL Connecting the Vent PipeCAP HAS BEEN INSTALLED TO AVOID DOWNDRAFTS AND/OR COLD AIRRoof Pitch CONNECTED TO THE EXHAUST THE EXHAUST PIPE MUST ONLY BESTARTING COLLAR OF THE UNIT AND THE CENTER COLLAR OF THE TERMINATION CAPEXHAUST INLET AIRSTARTING COLLARInsert Step The Gas Control Systems Step Positioning Leveling, and Securing theTHIS UNIT IS NOT FOR USE WITH SOLID FUEL Standing Pilot Ignition SystemDO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS Step The Gas Supply LineFigure 7. Gas Supply Line Fireplace Step Gas Pressure Requirements Step Wiring thePressure Natural GasRemote Wall Switch Optional AccessoriesREMOTE WALL SWITCH OR THE WHEN SERVICING CONTROLS. WIRINGFigure 9. Fan Wiring Diagram Step Installing Logs and Ember MaterialPositioning the Logs Save the log instructions with this manualFigure 11. Placement of the Ember Material Figure 10. Glass AssemblySURROUND INSTALLATION Step Installing Trim SurroundsANY MANNER NOTE REMOVE FRONT TRIM DOOR AND GLASSPage Step Before Lighting the Appliance Step Lighting the Appliance After the InstallationReview safety warnings and cautions Double-checkfor faulty componentsMaintaining and Servicing Your Appliance Appliance MaintenanceTURN OFF THE GAS BEFORE SERVICING YOUR APPLIANCEFigure 15. Pilot/Ignitor Flame Patterns Figure 14. Burner Flame PatternsMAKE SURE THE FLAMES ARE STEADY-NOT LIFTING OR FLOATINGAccessories ReplacementStanding Pilot Only Parts andPART Standing Pilot ContinuedPART DESCRIPTION PART NUMBERAccessories Standing Pilot ContACCESSORY P A R T

Standing Pilot Continued

PART NUMBER

SRV475-328A

SRV57-800

SRV60-801

SRV436-525A

GLA-ATG

SRV475-360A

SRV459-337