Bakers Pride Oven BCO-E Blower Wheel Set Screw Wheel Puller Bolt 3/8” Hex Motor, D. Servicing

Figure 1 Cleaning The Blower Wheel

Blower Wheel

Set Screw (2)

Wheel Puller Bolt 3/8” Hex

Motor

D. SERVICING:

NOTE: THIS APPLIANCE MUST BE SERVICED BY AN AUTHORIZED SERVICE AGENT.

(1)Power supply to the unit must be disconnected before any service is performed.

(2)Most of the service on the unit can be performed from the front and/or control panel side.

(3)For proper servicing, access to the control panel side of the unit will be required.

(4)It will be necessary to have access to the back of the oven for service needs related to the electric power supply.

(5)A system wiring diagram is provided in this manual and on the back of the service panel on the right side of the oven.

(6)All servicing should be performed by a factory-authorized technician only.

(7)For proper maintenance and repairs, call the factory toll free (800-431-2745) for an authorized service agency in your area.

!	WARNING: RISK OF FIRE. When stacked two high maximum, use stacking kit	!
	part # E3771A only.
!	CAUTION: This product, when stacked, has more than one power-supply	!
	connection point. Disconnect all power supplies before servicing.
Figure 2	OPEN RACK STAND ASSEMBLY INSTRUCTIONS: BCO-E & GDCO-E

Open Style Support Leg Not Supplied With Kit

1

2

3

4

5

6

Assembly Instruction

1.Place undershelf (6) between legs & secure with 1/4-20 UNC screws (4), flat washers (3) & locknuts (2). The holes for mounting the wire racks should be toward the front of the oven.

2.Place open rack supports (1) between legs & secure with 1/4-20 UNC screws (4), flat washers

(3) & locknuts (2).

3.Slide wire rack supports (5) into position using the holes in the undershelf (6) as a guide.

Item	P/N	Description	Quan
1	21818232	Support, Open Rack	2
2	770504	Lock Nut 1/4-20	12
3	8519600	Washer, Flat 1/4”	12
4	8208200	Screw, 1/4-20 x 3/4”	12
5	21816807	Support, Wire Rack	2
6	21818220	Undershelf, Gas Oven	1

8