Mounting your print:
1.Be sure all laminator parts (i.e. safety shield, feed table, etc.) are in their proper positions and the laminating film is loaded correctly on top and bottom mandrels. (See page
2.Using the supplied allen wrench back out the four pressure adjustment screws 1 full turn for each 1/16” thickness of the board. Ie. 3/16” 3 full turns. (Be sure to count the number of turns so the screws can be returned to original position).
FIGURE 9
3.Turn the heat switch to the ON position.
4.Set the temperature using table 1 on page 10 as a guide. You may need higher temperatures than indicated for mounting and laminating mount board.
5.Turn the fans on.
6.Perform a test mount to ensure proper settings for successful mounting. If any adjustments are necessary make them now and run another test. Repeat this step until you obtain desired results.
7.Feed the print and mount board slowly and evenly into the laminator behind a leader board so that the leading edge of your mount board does not become compressed. Pull back the peeled back release liner before it enters the rollers.
8.You may mount subsequent prints now, one directly behind the other so that the board in front becomes the leader board.
9.Once your last print has completely exited the laminator, turn the MOTOR and FAN switches OFF and use the trimmer to remove the mounted and laminated prints.
13
