Input Module
•Use the Input Wizard to configure inputs.
•Use the Input Management Menu to fine tune inputs.
Output Modules
Each module provides three outputs, which can drive one (or more) attached displays from any portion of a selected source image.
• Use the Setup Wizard to configure outputs and groups.
NNI Output Module |
| DVI Output Module |
Runs next generation LEDs. |
| Runs legacy LEDs. Each |
Each output is limited to |
| output is limited to |
1024 x 768 pixels. |
| 800 x 600 pixels. |
|
|
|
System Module
The System module provides connections for Ethernet, synchronization (genlock), monitoring, DMX and diagnostics.
Under the
•Use the Ethernet Menu to configure Ethernet parameters.
•Use the Monitor Setup Menu to set monitor output parameters, test patterns, and the monitor’s video source.
•Use the Genlock Menu to set the master sync source, and individual bank genlock sources.
Latches
Used for precise insertion and
removal. See the “Module
Insertion and Removal” section.
Expansion Out
Connects input modules for
external and
stacking configurations only.
RGBHV Input
Accepts RGBHV inputs up to QXGA (2048 x 1536), with a max. 240 MHz pixel clock.
HD / SDI Input
Accepts:
• 2 x SDI
•2 x
•1 x SDI and 1 x
•1 x Dual
Component Input
Accepts Composite,
and Component. See the
“Format Connection Table.”
DVI / Expansion Input
Accepts single or dual DVI inputs, with resolutions up to QXGA (2048 x 1536) with a max. 240 MHz pixel clock.
EXP OUT 1 - HD/SDI - 2 DVI / EXP IN
RGBHV Y / COMP C / Pb Pr
LED Outputs | LED Outputs |
Three | Three |
connectors are | connectors are |
provided for NNI | provided for DVI |
outputs. | outputs. |
LED OUT 1 | LED OUT 1 |
LED OUT 2 | LED OUT 2 |
LED OUT 3 | LED OUT 3 |
| WARNING |
Output Module connectors use proprietary | |
signals and pinouts. Do not connect the | |
outputs to anything other than the inputs of | |
| Barco LED tiles. |
| DMX Control |
|
|
|
Currently not implemented. |
|
|
| |
| Genlock Inputs |
|
|
|
• | Single: connect | H / |
|
|
| composite sync or |
|
| |
| CS INVIN | GENLOCK | DMXIN | |
| and V IN. | |||
| black burst to H/CS IN. |
|
|
|
• | Separate: connect H |
|
|
|
| and V sync to H/CS IN |
|
| DMXTHRU |
Expansion Lock Out | LOCK | EXP | ||
|
|
| ||
| For external stacking |
|
|
|
| configurations, provides |
|
|
|
sync and communications |
|
|
| |
| to additional | MONITOR |
| ETHERNET |
RGBHV Monitor Out |
| |||
|
|
| ||
| DVI Monitor Out |
|
|
|
Use the Monitor Output |
|
|
| |
Menu to set resolution and |
|
| DIAGNOSTIC | |
video source. Both outputs |
|
| ||
|
|
| ||
| show the same video. |
|
|
|
| Ethernet |
|
|
|
100BaseT connection for |
|
Director Toolset | Diagnostic Port |
communications. Use the | |
Ethernet Menu to set | For factory and technical |
parameters. | support use only. |
|
|