Barco MIVD 1218 6. Technical specifications

User manual MIVD 1218

30

6. Technical specifications

GEOMETRY

• Screen size: 46 cm

(18.1")

• Display area: 359 mm x

287 mm (14.1" x 11.3")

• Aspect ratio: 5:4

VISUAL PERFORMANCE

General

• Pixel arrangement: sub-

pixel vertical stripes

• Pixel pitch: 0.2805 mm x

0.2805 mm (0.011" x

0.011")

• Panel contrast ratio:

550:1 (typical)

• Panel viewing angle: +/-

85° (at CR = 10:1)

Panel

• Thin film transistor active

matrix grayscale LCD

• PVA technology

• Amorphous silicon TFT

• Backlight: 6 cold

cathode fluorescent

lamps

Luminance

• Calibrated: 500 cd/m2

(145.9 fL)

Resolution

• Up to 1280 x 1024 (1.3

MegaPixel)

INPUTS

DVI

• Complies to DVI Rev.

1.0 spec

Video

• Connector type: BNC

• Inputs provided:

composite video

• Video input voltage:

nominal 0.7Vpp

• Termination: 75 Ohm

Sync

• Connector type: BNC

• Inputs provided: HS/CS

and VS

• Sync input voltage:

nominal 2Vpp

• Termination: 75 Ohm

SCANNING SYSTEM

• Horizontal Frequency:

15 - 95 kHz

• Vertical Frequency: 50 -

140 Hz

• Interlaced / non-

interlaced signals

• Interlaced: Fuzzy-logic-

based de-interlacing

• Multi-sync

• 14 programmable scan

modes

Contents

Main MIVD 1218 User Manual Page User manual MIVD 1218 3 Safety instructions CAN/CSA-C22.2 No. 601.1-M90 (c UL) Contents Page 1. Overview 1.1. Introduction Options Memory scan modes 1.2. Package contents 1.3. Controls and connectors Page 2. Installation 2.1. Precautions 2.2. Mounting the display (model without tilt & swivel foot option) 2.3. Portrait or landscape position (model with tilt & swivel foot option) 2.4. Connecting the signals Page 2.5. Routing the signal cables (model with tilt & swivel foot option) 2.6. Tilt and swivel positioning (model with tilt & swivel foot option) 2.7. Starting up 3. Operation 3.1. Introduction Navigating through the menus Saving changes 3.2. Controlling contrast and brightness* To enter the menu: To change contrast or brightness manually: To select the calibrated position: Additional information 3.3. Controlling the light output 3.4. Calibrating the display* When do you need to calibrate? Required test pattern To perform the calibrations: The different calibration functions: 3.5. Getting information General information Timing information 3.6. Adjusting Geometry Required test pattern To perform the adjustments: 3.7. Settings Input Selection Test Pattern Lookup Tables Filter* * Not in DVI mode Power Led ALC active DPMS active 3.8. Advanced settings CAL options OSD ALC Scan mode Factory reset Control wheel 3.9. Service 4. Maintenance Panel Cabinet To remove the glass panel: Cleaning instructions: 5. Troubleshooting Calibration not successful Pixel Faults 6. Technical specifications GEOMETRY VISUAL PERFORMANCE General Panel Luminance CONTROLS POWER SUPPLY APPROVALS DIMENSIONS H x W x D: