1. Installation proc ess

1. INSTALLATION PROCESS
About this chapter
Thischapter describes how to replace the (universal) lamp house from the FLM projector.
Adapted software for Universal Lamp House
TheFLM projector software must be upgraded to version 1.7.17 or later prior to using the Universal Lamp House. Thelatest FLM
projector software can be downloaded from the Barco secured web site https://my.barco.com (browse to the product page of the
FLMprojector). The FLM projector will not recognize the Universal Lamp House and will fail to start up the xenon bulb lampw hen
neglectingthis software upgrade. Use the Projector Toolset,which is also available on the secured Barco web site, to upgrade the
projectorsoftware. See user guide ofthe Projector Toolset for detailed instructions on how to upgraded the projector software.
Overview
• Switching off
• Removal of the lamp cover
• Removal of the lamp house
• Installationof the lamp house
• Installationof the lamp cover

1.1 Switching off

How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans decrease, at least 5 min.
3. Switch off the projector with the power switch.

1.2 Removal of the lamp cover

WARNING:Thisprocedure may only be performed by qualified technical service personnel.
Necessary tools
7mmflat screw driver.
How to remove the lamp cover of the projector ?
1. Release the two captive screws at the top and b ottomr ightside of the lamp c over,using a flat screw d river.
R5976922 FLM LAMP HOUSE 18/11/2008 1