1. Installation process

3. C laspthe lam p houseby itshandles and gently slide the lamp house into its socket. Note that the compartment is provided with
guides (G) to position the lamp house correctly.
G
C
Image1-5
4. Push the lamp house forward until it slides fully into the projector.
5. Secure the correct position of the lamp house by tightening all three spring lock screws as illustrated.
Image1-6
6. Reinstall the lamp cover of the projector, see "Installation of the lamp cover", page 4 .
While starting up the projector,the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to startu pthe projector.
1.5 Installation of the lamp cover

Necessary tools

7mmflat screw driver.

How to install the lamp cover of the projector ?

1. Install the lamp cover of the projector doing the following:
a) Bring the lamp cover towards its final position (A),
b) then gently push the locking stud at the left top corner (B) into its receiver,
c) then gently push the locking stud at the left bottom corner (C) into its receiver.
4R5976922 FLM LAMP HOUSE 18/11/2008