3. OVERVIEW USER’s CONTROL S
Image3-2
CineVERSUM 80 controls
Controls function description
Ref. Function Description
1Infra Red Receiver Reception diode for the IR signals from the Remote Control. Allows
switching On/Off (Standby) of the projector separately and controlling
theCineVERSUMMaster.
2Infra Red Reception LED indicator Lights up when a valid IR signal from the Remote Control has been
captured.
3Standby LED Lights up continuously: projector in the operation mode.
Lights up repeatedly 2 times short, 1 time long: projector in the standby
mode
Blinks fast: projector in the cooling down mode after switching off
(duration 1 min.).
Lights up repeatedly 1 time long, 1 times hort: projector has been started
up in the cooling down mode, waiting for lamp ignition.
4Main power switch Button pressed, switches the projector in the ’Standby’ mode. This mode
is indicated by the standby LED which lights up repeatedly 2 times short,
1 time long.
Table 3 -2
3.3 Cine VERSUM 50

Rear and Front view

The only hardware controlo nt he CineVERS UM 50 is theM ainP owerSw itch(1), located at the backside of the screen itself. This
switch puts the Screen in the ’OFF’ or Standby position ’ON’. From the Standby position, the operation is controlled by the Cine
VERSUM Master.
The status ofthe Plasm a screen isindicated by a blue LED (3), located at the bottom on the right of the screen. In the same corner
an IR LED (2) is mounted .
8R5976490 CINE VERSUM S YSTEM 17012003