4. Getting started
4.2 Terminology overview
Overview
The following table gives an overview of the keys.
Image 4-2
1Function keys user programmable keys with functions for direct access.
2MENU Menu key, to enter or exit the Toolbar menu.
3Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9.
4LOGO key allows to recall the stored Logo (not in PiP mode)
5PAUSE to stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6STBY standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch.
Attention : Switching to Standby. When the projector is running and you want to
go to standby, press the standby key for 2 seconds.
7MUTE to interrupt the sound reproduction (audio = optional.
8AUTOIMAGE Auto image, to center the image on the active LCD surface.
9Digit buttons direct input selection.
9b SOURCE button this button allows to switch through the active (scanned) inputs
R5976367 BARCOIQ GRAPHICS 500 01/02/2007 33