9. Service Mode
Start Up
1. Push the cursor key ↑or ↓to highligh t Identification. (menu 9-4)
2. Press ENTER to display the Identification screen. (menu 9-5)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑or ↓
then <ENTER>
<EXIT> to return
Menu9-4
SLM R9+
Proj. address: 001
Soft. version: 3.0
Config: front/ceiling
Bautrate PC: 9600
Network module: yes
Text: on
Serial No:1010200
Run time: 100 h
Select with ↑or ↓
then <ENTER>
<EXIT> to return.
Menu9-5
9.4 Password
Overview
• Change Password
• Access Control List
9.4.1 Change Password
How to enable or disable the password function?
This item isp assword protected when the password strap is installed.
Thepassword function is enabled when the passwordstrap, second switch of S2 on the controller module is installed. Consultan
authorized Barco service technician to change the strap position.
About password types.
3 differentpassword levels are built in, in the projector software.
The different levels are:
• owner
•user
• guest
Dependingon your password level some password protected items are accessible and others not. Theowner(which has the highest
level)can set up via the ’Access control list’ the accessibility of the different items. See’Access Control List’.
Get access to the controller module
1. Power down the projector and disconnect the power cord from the wall outlet.
2. Loosen the indicate screws of the input box. (image 9-1, image 9-2)
3. Pull out the input box by both handlers.
4. When a m etal top cover of the box is mounted, remove first by turning out the screws. (image 9-3)
5. When looking inside the box, the controller module with the switche sis situated in the middle of the box. (image9-4)
6. Change the position of S2.
102 R5976801 SLM R9+ 20/10/2004