Electrical connections
Before connecting the oven to the mains power supply, make sure that: - The supply voltage corresponds to the specifications on the data plate on the front of the oven. - The mains supply has an efficient earth (ground) connection complying with all applicable laws
and regulations. Correct earthing (grounding) is a legalGB requirement. The power cable should never reach a
temperature 50° C above ambient temperature at any point along its length. If a fixed appliance is not provided with a power cable and plug, or some other device permitting it to be disconnected from the mains electricity supply, with a gap between the contacts big enough to guarantee class III overvoltage protection, then such a device must be fitted to the power supply in compliance with the regulations governing electrical installations. The socket or switch must be easily reachable with the oven fully installed.
CABLE TYPES AND MINIMAL DIAMETERS
| SASO |
|
|
|
|
|
|
|
|
|
|
WARNING! Before connecting the warming drawer to the electrical circuit, verify that the voltage and the frequency correspond to those indicated on the label located inside the heating block, which should be kept along with this manual.
The electrical attachment must be made using bipolar switch capable of powering the appliance and that has a gap of 3 mm (minimum) to guarantee disconnection in case of emergency or when cleaning the warming drawer.
Connect the appliance to the ground circuit to conform to safety regulations regarding electrical systems.
ATTENTION! THE WARMING DRAWER MUST BE
CONNECTED TO THE GROUND CIRCUIT.
In the event of the failure of the cable supplied with the warming drawer, replace it with an original replacement part provided by the Service Department.
The manufacturer and retailers will not be liable for property damage and personal injury caused by a failure to follow the instructions provided in this manual.
25
