7 | BAUMATIC BDW13, BDW14 dishwasher user manual |
RINSE AID
•TO OPEN THE DISPENSER, TURN THE CAP TO THE ‘OPEN’ (LEFT) ARROW AND LIFT IT OUT.
•POUR THE RINSE AID INTO THE DISPENSER. BE CAREFUL NOT TO OVERFILL.
•REPLACE CAP BY INSERTING IT ALIGNED WITH ‘OPEN’ ARROW & TURN IT TO THE CLOSED (RIGHT) ARROW.
•THE RINSE AID IS RELEASED DURING THE
FINAL RINSE TO PREVENT WATER FROM FORMING DROPLETS ON YOUR DISHES THAT CAN CAUSE SPOTS AND STREAKS. IT
ALSO IMPROVES DRYING BY ALLOWING WATER TO FALL OFF THE DISHES.
•YOUR DISHWASHER IS DESIGNED TO USE LIQUID RINSE AIDS. THE RINSE AID
DISPENSER CAN BE FOUND INSIDE THE DOOR NEXT TO THE DETERGENT DISPENSER. TO FILL THE DISPENSER, OPEN THE CAP AND POUR THE RINSE AID INTO THE DISPENSER UNTIL THE LEVEL INDICATOR TURNS COMPLETELY BLACK. THE DISPENSER HOLDS ABOUT 100ML OF LIQUID RINSE AID.
•BE CAREFUL NOT TO OVERFILL THE
DISPENSER – THIS COULD CAUSE FROTHING. WIPE AWAY SPILLS WITH A DAMP CLOTH. DON’T FORGET TO REPLACE
THE CAP BEFORE YOU CLOSE THE DISHWASHER DOOR.
NOTE: IF YOU HAVE SOFT WATER, YOU MAY NOT NEED RINSE AID FOR IT MAY CAUSE A WHITE FILM TO DEVELOP ON YOUR DISHES.
ADJUSTING THE RINSE AID DISPENSER
•As with detergent, the amount of rinse aid needed for your dishes depends on the hardness of the water in your area.
Too much rinse aid can result in foaming and cause cloudiness or streaks on your dishes. If your water is very soft, you may not need rinse aid. You can always dilute the rinse
aid with an equal amount of water.
The rinse aid dispenser has six settings. ALWAYS START WITH THE DISPENSER SET ON “1”. IF SPOTS & POOR DRYING ARE A PROBLEM, INCREASE THE AMOUNT OF RINSE AID DISPENSED BY REMOVING THE DISPENSER LID AND ROTATING THE DIAL TO “2”. IF THE DISHES ARE STILL NOT DRYING PROPERLY OR ARE SPOTTED, ADJUST THE DIAL TO THE NEXT HIGHER NUMBER UNTIL YOUR DISHES ARE
***NOTE: Please read the notes for detergent use on p. 13.
WHEN TO REFILL THE RINSE
AID DISPENSER -
warning light (SEE control panel) is not on, you can judge the rinse aid level by looking at the black dot on the rinse aid dispenser. As the rinse aid level decreases, the black dot shrinks. Never let the rinse aid get below ¼ full.
7
