Bazooka ELA500.1, MAA60.4 Speaker Connections Tri-Mode, Left Mid / Tweeter 4 Ohm 2 Ohm Minimum

SPEAKER CONNECTIONS (TRI-MODE)

The amplifier is capable of running in a Mono / Stereo mode. This feature gives the amplifier the ability to run stereo satellites (midbass & tweeter) simultaneously with a mono subwoofer.

These connections are more complicated because they require the use of passive crossover networks (Not provided) to divide the frequencies to the speakers. We have included a sample diagram for 4 Ohm connections. If you wish to use multiple speakers to achieve a lower impedance and higher power, it is strongly recommended that you seek professional advice from your BAZOOKAd retailer before attempting to make these connections.

Please Note: In the Tri-mode configuration, the amplifier’s built-in crossover must be set to the ”FLAT” position so the speakers receive full range output.

				+12V	REM	GND			SPEAKERS
AUX		AMP						AUX
7.5A	20A	20A	20A				OUTPUT

BRIDGED

Left

Mid / Tweeter

4 Ohm

(2 Ohm Minimum)

L E G E N D

100 F

- mH4

-

+

100 F

Right

Mid / Tweeter

4 Ohm

(2 Ohm Minimum)

NON-POLAR INDUCTOR

CAPACITOR(COIL)

+-

Mono Woofer

8 Ohm

(4 Ohm Minimum)

CAUTION! In Tri- mode operation, the amplifier must see a 2 Ohm load or higher for the stereo satellites and no lower than 4 Ohms for the subwoofer(s). Any lower than the above mentioned impedance will cause the amplifier to overheat and possibly cause permanent damage to the amplifier.

12