BBE user manual Congratulations on the purchase of your BBE DI-10 direct box

Congratulations on the purchase of your

BBE DI-10 direct box!

Use the following illustrations as a starting point for proper placement of the BBE DI-10.

The BBE DI-10 is an active direct box used for converting line out and speaker out signals to balanced and unbalanced signals. The user also has the ability to select between two frequency responses (flat, or speaker compensated). Using the outputs from the DI-10, the user can direct feed to a mixer, recorder, or sound reinforcement system.

The features that make up the BBE DI-10 are:

1.	Speaker thru and Speaker input jacks.
2.	1/4” phone jack for line level signal input and output.
3.	XLR jack for mic level, balanced output.
4.	Filter switch to operate the speaker simulating filter.
5.	Tri-mode powering for three different modes of powering:
	a) internal 9V battery,
	b) 9VDC external power source, and
	c) 48V phantom power source through the XLR connector.
6.	Tri-mode power scanning feature which scans the three power

SPEAKER OUT

SPEAKER IN

BALANCED OUTPUT

DI-10

SPEAKER THRU

MIXING CONSOLE

AMP & SPEAKERS

LINE OUT

LINE IN

BALANCED OUTPUT

DI-10

PA SPEAKER

PA SPEAKER

PA SPEAKER

sources and uses only the highest source of power and shuts off the

other power sources.

IMPORTANT

Before you begin, please check the contents within this box to insure that included are:

1.The BBE DI-10.

2.Four (4) Rubber Feet for table-mount application.

3.The BBE DI-10 user’s manual.

4.9VDC External Power Source.

MIXING CONSOLE

AMP & SPEAKERS

PA SPEAKER

i - BBE DI-10 INSTALLATION INSTRUCTIONS