Fine tuning your new BDI Avion Home Theater Furniture
These steps are to be followed after you have unpackaged and completed the simple assembly instructions for your Avion or Avion Noir stand. Due to jostling in freight or perhaps an uneven floor, the doors and drawers on your Avion stand may not appear to be in perfect alignment. Making a few minor adjustments can rectify this situation. Be aware that depending on your situation, patience and a bit of trial and error are required. The
INCORRECT! Door is out of alignment with the rest of the unit.
CORRECT! Door is sitting squarely and evenly spaced on tops and sides.
STEP 1 - Level your Avion unit (if needed) |
| |
The levelers which are concealed within the legs can be adjusted from inside the |
| |
Avion cabinet to compensate for an uneven floor or to secure your cabinet so that it |
| |
does not roll. If you are having difficulty with misaligned doors, it is recommended |
| |
that you first retract all levelers and make sure that the unit is resting on it’s wheels. |
| |
If the center section on a |
| |
hangs below the side doors) raise the levelers on the center leg to compensate for |
| |
this. | Step 1: Level your Avion unit. | |
|
| |
|
|
|
STEP 2 - Adjust Door Hinges (if needed) |
| |
The doors on your Avion stand should be perfectly spaced |
| |
and the doors should open and close freely without |
| |
rubbing against the door frame. Adjustments may be |
| |
made to the Avion door hinges with the use of a Phillips |
| |
head screwdriver. The hinge hardware has three |
| |
adjustment screws. |
|
•By adjusting Screw 1, the door will move left and right within the frame. For best results, make minor adjustments to top and bottom hinge for best results.
•If adjusting Screw 1 has not achieved the desired result, you can adjust Screw 2 and the door will move up and down within the frame (the top and bottom hinges need to be adjusted the same amount).
•Adjusting Screw 3 will cause the entire door to move in and out, opening and closing the gap between the door
frame and cabinet. This screw rarely needs adjustment. | Step 2: Adjust Door Hinges. |