RACKTUNER BTR2000

Acoustic indicator

The selected tempo is also output at the SOUND or MAIN connector.

+If your instrument is plugged into INPUT 1, the metronome click is output only through the SOUND connector. If it is plugged into INPUT 2, and the SOUND output is not in use, the metronome click is output together with the instrument signal from the MAIN connector.

You can change the volume of the click at any time and thus control the volume ratio between instrument and click if you are listening to both using one amp.

1. Briefly press the SOUND/METRONOME button. The SOUND LED above the button lights up.

2. With the wheel you can adjust the volume of the click with 12 volume levels.

+Even at the lowest volume level (1), the metronome click is still audible. The click can be shut off with the MUTE button.

3. If the volume is not changed for some time or if the SOUND/METRONOME button is pressed again, the SOUND light goes out.

The metronome can naturally be muted without affecting the visual display.

1. Press the MUTE/LIGHT button.

2. The metronome click is muted and no longer output through the MAIN connector.

6. USING A FOOTSWITCH

Single footswitches can be plugged into the MUTE and SELECT connectors (not included).

+Use only non-latching footswitches! The BEHRINGER DUAL A/B SWITCH AB200 is ideally suited.

The following functions are available with the footswitch:

 

 

0RGH

 

 

 

TUNER

 

METRONOME

6ZLWFK

MUTE

To mute

 

To mute

MAIN output

 

MAIN output

SELECT

 

 

 

 

 

 

Toggle between INPUT1

 

Activate/deactivate

 

 

and INPUT2/MIC inputs

 

metronome

 

 

 

 

 

Table 6.1: Options overview

If you have a double footswitch such as the BEHRINGER FS112, it must be connected to the SELECT connector! Both functions (MUTE and SELECT) are then transmitted over a stereo connection and can be controlled using the two buttons.

14

6. USINGAFOOTSWITCH