PRO MIXER DJX700 User Manual
◊Merely switching the unit off does not mean that it is fully disconnected from the mains. When not using the unit for prolonged periods of time, please unplug the unit’s power cord from the power outlet.
[48]This is the connector for the power cable. This is where the advantage of a sophisticated internal power supply can be seen: the pulse behaviour of each amplifying circuit is mainly determined by the voltage reserves available. Each mixing console is equipped with numerous operational amplifiers (op amps) to process line level signals. Due
to limited output of their power supplies, many mixing consoles show signs of “stress” when subjected to heavy loads. But not your DJX700: the sound is always clear and transparent.
[49]FUSE HOLDER / VOLTAGE SETTING. Before connect- ing the unit to the mains, ensure that the voltage setting matches your local voltage. Blown fuses should only be replaced by a fuse of the same type and rating. On some units, the fuses holder can be switched to one of two posi- tions, i.e. 230 V and 120 V. Please note: should you desire to operate the unit outside Europe at 120 V, a higher fuse rating is required.
◊To disconnect power from main, pull out the main cord plug. When installing the product, ensure that the plug is easily accessible. If mounting in a rack, ensure that the mains can be easily disconnected by a plug or by an
[50]SERIAL NUMBER.
Initial operation
◊Ensure adequate air supply and to avoid overheating do not place the unit near radiators etc.
◊Before you connect your unit to the mains, please make sure that your local voltage matches the voltage required by the unit.
The fuse holder on the mains connector has 3 triangular markings, with two of these triangles opposing each other. The unit is set to the operating voltage printed next to these markers and can be set to another voltage by turning the fuse holder by 180°.
!!Caution
Please note that when operating the unit at 120 V, a higher fuse rating is required. Please refer to the“Specifications”for details.
7
If you set the unit to a different mains voltage, be sure to use a fuse of the correct type and rating. Please refer to the “Specifica- tions” for details.
◊Blown fuses must be replaced by fuses of the correct rating! Please refer to the “Specifications” section for the applica- ble rating. Before you change the fuse, switch off the device and pull the plug to avoid electric shock or damage to the device.
The mains connection is made using the enclosed power cord and a standard IEC receptacle. It meets all international safety certification requirements.
◊Please make sure that all devices are properly grounded. For your own safety, never remove or disable the ground conductors from the devices or on the power cords. The unit must always be connected to the mains outlet with a protective grounding connection.
◊The sound quality may diminish within the range of power- ful broadcasting stations and
Shipment
Should your BEHRINGER product malfunction, it is our intention to have it repaired as quickly as possible. To arrange for warranty service, please contact the BEHRINGER retailer from whom the equipment was purchased. Should your BEHRINGER dealer not be located in your vicinity, you may directly contact one of our subsidiaries.
Corresponding contact information is included in the original equipment packaging (Global Contact Information/ European Contact Information). Should your country not be listed, please contact the distributor nearest you. A list of distributors can be found in the support area of our website (http://www.behringer.com).
Registering your purchase and equipment with us helps us process your repair claims more quickly and efficiently.
Your product was carefully packed at the factory to ensure safe transport. Nevertheless, if the box is damaged inspect the unit immediately for signs of damage.
◊If the unit is damaged please do NOT return it to us, but notify your dealer and the shipping company immediately; otherwise, claims for damage or replacement may not be granted.
◊Always use the original box to prevent damage during stor- age or transport.◊Make sure that children cannot play unsupervised with the unit or its packaging.
ENGLISH