EUROGRAND EG2180
4. Keyboard Assembly
Pedal
Cable Jack
Headphones
Jack
| Screws to fasten |
| the keyboard with |
Pedal adjuster | side panel |
1.Position the holes at the bottom of the Keyboard against the holes in the side panel brackets.
2.Use four screws {6} to fasten the Keyboard.
3.Insert the pedal cable connector into the pedal jack located at the rear of the Keyboard.
++ Be sure that the connector is inserted in the correct orientation. Make sure that the cable clamp fastens to the pedal cable.
++ Rotate the pedal adjuster until it comes in firm contact with the floor surface. If the adjuster is not in firm contact with the floor,the pedal will wobble and cause malfunctions.
5. Headphone Hanger Assembly
1.Use two screws {9} to fasten the Headphone Hanger [10] to the underside of the Keyboard.
Technical specifications and appearance are subject to change without notice. The information contained herein is correct at the time of printing. All trademarks (except BEHRINGER, the BEHRINGER logo, JUST LISTEN and EUROGRAND) mentioned belong to their respective owners and are not affiliated with BEHRINGER. BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colors and specifications may vary slightly from product. Products are sold through our authorized dealers only. Distributors and dealers are not agents of BEHRINGER and have absolutely no authority to bind BEHRINGER by any express or implied undertaking or representation. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose, without the express written permission of BEHRINGER International GmbH.
ALL RIGHTS RESERVED. © 2008 BEHRINGER International GmbH,
47877
Tel. +49 2154 9206 0, Fax +49 2154 9206 4903
4 | Headphone Hanger Assembly |