16EUROGRAND EG2280USB/EG8280USB User Manual

5)Switch on the acoustic metronome signal by pressing the CLICK button, if you want to make a metronome-backed recording.

6)Start recording by pressing the button or simply start playing on the keyboard. The current meter is constantly shown in the display.

◊If the display starts flashing during recording and reads the message FUL, this is to warn you that the recording memory has been used up.

All data recorded up to this point will be stored, however, but recording process will be terminated.

7)Once your recording is finished stop the sequencer by pressing the button again.

◊Recording mode will thus be canceled automatically.

◊You can only activate those tracks for playback which actually contain note information.

2)If you want to have a metronome-backed playback, press the CLICK button to switch on the metronome.

3)Press the MODE button in the TEMPO/EDIT MODE section until the TEMPO LED lights up, then use the two Down/Up buttons to adjust the playback tempo.

◊You can play back a recording at its original tempo by pressing the two Down/Up buttons at the same time.

4)Press the button to play back the recording. The current meter is constantly shown in the display.

5.5.3 Playing back pieces of music

This section describes how to play back the music piece you have just recorded.

1)Press the TRACK 1 and TRACK 2 buttons until the green PLAY LED above the buttons lights up. This is to activate the tracks for playback.

◊During playback the two tracks can be switched on/off at any time.

◊You can accompany the music sequencer playback with the currently selected sound.

◊TIP: If the right-hand part has been recorded on track 2 and the left-hand part on track 1, you can switch off either of the tracks and practice its part live during playback. The volume of the muted track is adjustable. If necessary you can play it back in the background at low volume for support (see chapter 5.5.5).

5) To stop the playback, press the button

behringer.com