Behringer Eurorack +, +

EURORACK UB1222FX-PRO

Fig. 2.7: Aux send connectors MON and FX

MON SEND

Connect the input of your monitor power amp or an active

monitor system here to make the monitor mix audible to the

musicians on the stage. The signal mix is created using the

channels MON controls.

FX SEND

The FX SEND connector outputs the signal you picked up

from the individual channels using the FX controls. You can

connect this to the input of an external effects device in order to

process the FX bus master signal. Once an effects mix is created,

the processed signal can then be routed from the effects device

outputs back into the AUX RETURN connectors.

+If the connected effects processor receives no

input signal, the FX MUTE switch is probably pressed

and/or the FX SEND control is too low. This also goes

for the built-in effects processor.

+Adjust your external effects processor to 100% wet

(effects signal only), because the effects signal is

added to the main mix along with the dry channel

signals.

Fig. 2.8: Aux return connectors

AUX RETURN 1

The AUX RETURN 1 connectors generally serve as the return

path for the effects mix generated using the FX send. This is

where you connect the output signal of the external effects

device. If only the left connector is used, the aux return 1

automatically operates in mono.

+You can also use these connectors as additional

line inputs.

AUX RETURN 2

The AUX RETURN 2 connectors are used exactly the same

way as the AUX RETURN 1 connectors. If these connectors