12.Reposition left hand side feet on the opposite side.(10)
13.Unscrew and remove the bottom door hinge pin bushing/door stopper using a
Unscrew and remove the upper door middle hinge pin bushing/door stopper using a
Important: This part cannot be used on the opposite side; left hand side middle hinge pin bushing/door stopper part is supplied in the plastic bag.(11)
15.Fit upper door left hand side middle hinge pin bushing/door stopper supplied in the plastic bag using cross- headed screwdriver.(13)
16.Reposition three small plastic plugs on the left hand side, which are covering middle hinge holes, on the opposite side to cover holes left empty. (14)
17.Locate and
18.Locate the middle hinge pin to middle hinge pin bushing of upper door on the left hand side and
19.Reposition the screw fitted to lower hinge hole on the left hand side at the bottom of the cabinet on the opposite side.(17)
20.Locate and
21.Carefully stand the appliance upright and adjust the two front feet if necessary.
22.Check that doors open and close easily, they are aligned correctly and that there are no gaps allowing ir into the cabinet. If there are gaps between the door seal and the cabinet, adjust the door seal by gently pulling away from the door using fingers.
23.Check that all the hinge screws are tightened. Avoid over tightening the screws.
24.Put all items, fittings back in the appliance.
25.Fit upper door top trim and front top panel plastic hinge covers. Upper door top trim hinge covers are supplied in the plastic bag.(20)
26.Wait for at least 4 hours to allow the system to settle before switching on.
27.Once the correct storage temperatures have been reached in the appliance, put back all the food.
Using the screws and plastic plugs supplied in the installation kit inside the fridge, fit handles to the desired side (see diagram P12 for locations)
11
EN
