|
| Installation |
|
|
| 3 |
|
| |
| TRANSPORTATION | IMPORTANT : Care must be taken |
| |
| while cleaning / carrying the appliance | |||
| INSTRUCTIONS | to avoid touching the bottom of the | ||
| 1.The appliance should be transported | condenser metal wires at the back of | ||
| only in a vertical upright position. The | the appliance as you might injure your | ||
| packing as supplied must be intact | fingers and hands. | ||
| during transportation. | Do not attempt to sit or stand on top | ||
| 2.If during the course of transport | of your appliance as it is not designed | ||
| the appliance has to be transported | for such use. You could injure yourself | ||
| horizontally, it must only be laid on its | or damage the appliance. | ||
| right hand side when standing in the | “IMPORTANT: Make sure that | ||
| front of the appliance. After bringing | mains cable is not caught under the | ||
| it to upright position,it must not be | appliance during and after carrying | ||
| operated for at least 4 hours to allow | / moving the appliance, to avoid | ||
| the system to settle. | the mains cable becoming cut or | ||
| 3.Failure to comply with the | damaged.” | ||
| above instructions could result in | Do not allow children to play with | ||
| damage occuringto the appliance. | the appliance or tamper with the | ||
| The manufacturer will not be held | controls. BEKO declines to accept any | ||
| responsible if these instructions are | liability should the instructions not be | ||
| disregarded. | followed. | ||
| 4.The appliance must be protected | IMPORTANT | ||
| against rain, moisture and other | INSTALLATION | ||
| atmospheric influences. | INSTRUCTIONS | ||
| 5.When positioning your appliance | 1. The space in the room where the | ||
| take care not to damage your flooring, | appliance is installed must not be | ||
| pipes, wall coverings etc. Do not move | smaller than 10 cubic metres. | ||
| the appliance by pulling by the door or | 2. This appliance has been designed | ||
| handle. | to operate in ambient temperatures up | ||
| 6. Empty any water in the drain | to 32 degrees C (90 degrees F) and | ||
| tray before moving. See section | is equipped with Advanced Electronic | ||
| ‘Defrosting’ and ‘Care & cleaning’ for | Temperature Control System [AETCS] | ||
| further information. | which ensures that at the advised | ||
| 7. Make sure that the defrost water | setting [4 - four on the knob] the frozen | ||
| pipe at the back of the product is fixed | food in the freezer will not defrost | ||
| to the plastic evaporating pan on the | even if the ambient temperature falls | ||
| top of the compressor, to avoid defrost | as low as | ||
| water spillage on the floor. | the product MUST NOT be placed in | ||
|
|
| low ambient temperatures because | |
|
|
| the freezer will not reduce to it’s | |
|
|
| standard operating temperature. Once | |
7
EN
