Filling the Rinse Aid
Dispenser
Rinse aids allow washing water to rinse off more cleanly and prevent watermarks or streaks on the dishes. Only use rinse aid designed for use in dishwashers.
Note
If you use “2 in 1” or “3 in 1“ detergents
/tablets, you do not need an additional rinse aid.
Open the rinse aid dispenser by pressing the locking lever (B)
Carefully pour in rinse aid to the MAX mark. Close the lid until it clicks (3).
Carefully wipe off spilled rinse aid. Excessive rinse aid causes excessive foam formation, which may hinder cleaning.
Set the dose of rinse aid
The dose of rinse aid to be used can be set by means of the dispenser regulator (between levels 1 and 6) (4). Your appliance is
Only change the setting if the following applies after washing:
•Watermarks are visible on the dishes: Set dosage higher
•Streaks are visible on the dishes:
Set dosage lower
1013 |
� |
� |
� |
Filling the Detergent
Dispenser
Note
Only use detergents formulated for use in dishwashers.
Open the detergent container by pushing the locking lever to the right (A).
The lines on the inside of the detergent container will help you measure the correct amount of detergent.
The detergent container holds a total of 40 cm³ of detergent (1).
11
GB