37 / 44 EN
Troubleshooting
Foam is overflowing from the detergent drawer.
•Toomuchdetergentisused.>>>Mix 1 tablespoonful softener and ½ l water and pour into the main wash
compartment of the detergent drawer.
•Putdetergentintothemachinesuitablefortheprogrammesandmaximumloadsindicatedinthe“Programme
andconsumptiontable”.Whenyouuseadditionalchemicals(stainremovers,bleachsandetc),reducethe
amount of detergent.
Laundry remains wet at the end of the programme
•Excessivefoammighthaveoccurredandautomaticfoamabsorptionsystemmighthavebeenactivateddueto
toomuchdetergentusage.>>>Use recommended amount of detergent.
•Machinedoesnotswitchtospinningstepwhenthelaundryisnotevenlydistributedinthedrumtopreventany
damage to the machine and to its surrounding environment. Laundry should be rearranged and re-spun.
AWARNING: If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional product
yourself.
Machine does not start. Nothing appears on the display.
Machinemaybeunplugged.>>>Check the plug and attach it to the socket.
Fusemaybedefective.>>>Check the fuse and have it replaced by a qualified electrician if necessary.
Powermaybeout.>>>Check if there is any power outage.
On/Offbuttonmightnotbepressed.>>>Press On / Off button.
Machine does not start when Start / Pause / Cancel button is pressed after selecting the programme.
Loadingdoormaybeopen.>>>Close the loading door.
Rinse symbol flashes in the display. (No Water symbol may also be lit depending on the model of your
machine).
Watermaybecutoff.>>>Make sure that the water is not cut off and press Start / Pause / Cancel button
again to start your machine.