ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the frequency shown on the rating plate inside the appliance corresponds to yourelectricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance be connected to the mains supply via a
suitable switched and fused socket. The appliance must be positioned so that the plug is accessible.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a BLOMBERG Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted.
IMPORTANT! FITTING A
DIFFERENT PLUG
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: (See diagram).
1.Connect the
(Earth) wire to the terminal in the plug marked ‘E’ or with the symbol 
or coloured green and yellow or green.
2.Connect the blue (Neutral) wire to the terminal in the plug marked ‘N’ or coloured black.
3.Connect the brown (Live) wire to the terminal in the plug marked ‘L’ or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.
Destroy the old plug which is cut off as a plug with bared cord could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be replaced an ASTABEAB approved BS 1362 fuse of the same
GREEN & |
|
YELLOW |
|
OR |
|
GREEN | 32mm. |
|
N
BLUE |
|
OR | 6mm. |
BLACK |
6mm.
L
BROWN | . |
OR | 6mm |
RED |
|
22mm. |
|
12mm.
FUSE
FITTED WITH 1362 13A FUSE ALWAYS | BS 1362 REPLACEMENT | CARTRIDGE FUSE |
BS | FIT |
|
rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.
CORD GRIP
5
EN
