Beko SS 137020 X manual 3Installation, Before operating your, refrigerator, Electric connection

3Installation

BPlease remember that the manufacturer shall not be held liable if the information given in the instruction manual is not observed.

Points to be considered when re-transporting your refrigerator

1.Your refrigerator must be emptied and
cleaned prior to any transportation.
2.Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any	3.Clean the interior of the refrigerator as
jolt before repackaging.
		recommended in the “Maintenance
3.Packaging must be tied with thick
		and cleaning” section.
tapes and strong ropes and the
	4.Plug the refrigerator into the wall outlet.
rules of transportation printed on the
		When the fridge door is open, the
package must be followed.
		fridge compartment interior light will
Please do not forget…
		come on.
Every recycled material is an
	5.You will hear a noise as the
indispensable source for the nature
		compressor starts up. The liquid and
and for our national resources.
		gases sealed within the refrigeration
If you wish to contribute to recycling
		system may also give rise to noise,
the packaging materials, you can
		even if the compressor is not running
get further information from the
		and this is quite normal.
environmental bodies or local
	6.Front edges of the refrigerator may feel
authorities.
		warm. This is normal. These areas
Before operating your
		are designed to be warm to avoid
refrigerator
		condensation
Before starting to use your refrigerator
	Electric connection
check the following:	Connect your product to a grounded
1.Is the interior of the refrigerator dry and
	socket which is being protected by a
can the air circulate freely in the rear
	fuse with the appropriate capacity.
of it?
	Important:
2.Please install the 2 plastic wedges
	• The connection must be in compliance
as illustrated in the figure. Plastic
		with national regulations.
wedges will provide the required
	• The power cable plug must be easily
distance between your refrigerator
		accessible after installation.
and the wall in order to allow the air
	• The specified voltage must be equal to
circulation. (The illustrated figure is
		your mains voltage.
only an example and does not match
exactly with your product.)

7

EN